Pigtronix Echolution Chrome Manuel d'utilisateur Page 9

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 20
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 8
Modulation Delay (M) – Classic Analog Delay
11. Turn all of the modulation controls fully counterclockwise, put the BLEND
control back to 12:00 and flip the “Delay Time Rage” switch to the M
(medium) mode. Explore the range of the DELAY TIME control in this mode
(100ms – 1.2sec).
12. Bring the DELAY TIME, LFO SPEED and CHORUS controls up to 12:00. You
will now hear a modulated delay effect. Experiment with various LFO
SPEED, DELAY TIME and CHORUS settings to grasp the range of available
textures. Longer delay times will require less chorus depth and shorter
delay times will require more chorus depth.
13. Bring the TREMOLO control up to 12:00 to mix in some amplitude
modulation of the delay signal.
Modulation Delay (L) – To Infinity… and beyond!
14. Bring all of the controls back to 12:00 and flip the “Delay Time Rage”
switch to the L (long) mode. Explore the range of the DELAY TIME control
in this mode (1sec – 12sec).
15. Repeat steps 12 and 13.
Multi-Taps – Get Rhythm
Each multi tap toggle switch is assigned to a fraction of the master delay time.
When a toggle switch is turned on, an echo is introduced at that fraction of the
master delay time. You may use any combination of the five available multi-
taps. The (phi) switch changes the values of all the fractions, but we’ll get to
that later.
*Note* - Each time an additional multi-tap is added, the delay signal is slightly
attenuated. If you wish to compensate for this attenuation, simply turn the
BLEND and DRIVE controls clockwise as needed.
*Note* - Turning the FEEDBACK clockwise will cause rhythmic patterns to
increase in complexity. Turning the FEEDBACK control counterclockwise will
keep things rhythmically tighter.
16. Bring all of the controls back to 12:00 and turn off the modulation section
by clicking the “Modulation Delay” footswitch. Using the Tap Tempo
footswitch, make sure the Tap Tempo delay time is set to approximately 1
second.
17. Play a single note to hear the echo occur at 1 second. Flip the toggle
switch marked 3/4 to the on position. Play a single note. You will now hear
two distinct echoes, the master delay at 1 second and the 3/4 tap.
18. Flip the toggle switches marked 1/4 and 1/2. Play a single note. You will
now hear four distinct echoes, the master delay at 1 second, as well as the
1/4, 1/2 and 3/4 taps. If you set the tap tempo to cycle once for each bar
Vue de la page 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Commentaires sur ces manuels

Pas de commentaire